Top-rated deck cleaning pros.

Get matched with top deck cleaning pros in Pelahatchie, MS

Enter your zip and get matched with up to 5 pros

Need a pro for your deck cleaning project in Pelahatchie, MS?

Select your specific project to find the pro for you.

TRUSTED BY PELAHATCHIE, MS HOMEOWNERS

  • Average homeowner rating star icon4.4
    Average homeowner rating
  • Verified reviews icon80
    Verified deck cleaning services reviews

Find Deck cleaning pros in Pelahatchie

...
Showing 1-10 of 59
Deck Cleaning questions, answered by experts

While the terms deck and porch are often used interchangeably, they are two distinct structures. A porch is a covered structure, usually attached to the front of a home, that offers protection from the elements. In contrast, a deck is an open, uncovered platform, often attached to the back or side of a home. Because porches have a roof, they typically require less maintenance than decks, but both features need regular cleaning and repairs to stay in good condition.

Building a deck without a permit could lead to fines for both the homeowner and the contractor. The exact penalties will depend on your state and municipal building laws. You might also be required to remove the deck and apply for a permit before you can build another. While it might be tempting to skip the permit to save a few bucks, it’ll cost you much more if you’re caught.

The best way to sand a deck is by cleaning it, sanding the boards and stairs with 60- or 80-grit sandpaper, and sanding the railings and posts with 80-grit sandpaper. You should sand in the direction of the wood grain to avoid damaging the timber. When sanding your deck, use medium pressure and aim for an even sand. Pressing too hard with a sander can damage decks, as most are softwoods.

Most building codes require that railing spindles (also known as balusters) on decks or stairs be spaced no more than four inches apart. This safety standard is often called the '4-inch sphere rule,' which means a sphere with a 4-inch diameter should not be able to pass through the opening between balusters. This rule is in place to prevent small children and pets from slipping through the railing. For the same reason, the space between the bottom rail and the deck or floor surface should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is essential to check your local building codes to ensure compliance before starting your project.

Typically, most residential wooden decks are designed to support approximately 40 pounds per square foot, including the deck’s weight and any items placed on it. While this is fine for typical use, it is usually not enough to hold the weight of a hot tub filled with water and people. To safely support a hot tub, your wood deck will likely require reinforcement. Therefore, it’s best to have a contractor or a structural engineer assess it before hot tub installation.

The Pelahatchie, MS homeowners’ guide to deck cleaning services

From average costs to expert advice, get all the answers you need to get your job done.