Top-rated sink repair pros.

Best sink repair pros near Latimer, MS

Enter your zip and get matched with up to 5 pros

Need a pro for your sink repair project in Latimer, MS?

Select your specific project to find the pro for you.

TRUSTED BY LATIMER, MS HOMEOWNERS

  • Average homeowner rating star icon4.4
    Average homeowner rating
  • Verified reviews icon876
    Verified sink repair services reviews

Top-Rated Sink repair pros in Latimer - Updated Nov 2026

No results for Sink repair pro in

Try adjusting your search criteria.
Sink Repair FAQs, answered by experts

The average cost to hire a plumber is typically between $45 and $200 per hour, with a common average rate around $125 per hour. This cost can vary based on your location, the plumber's experience, and the complexity of the job. Rates are often broken down by experience level: an apprentice may charge $45 to $90 an hour, a journeyman $60 to $110 an hour, and a master plumber $80 to $200 an hour. While hourly rates are standard, some plumbers may charge a flat fee for routine projects or offer project-based pricing. It's also common for plumbers to charge a minimum service or trip fee. For reference, some typical flat-rate costs for common jobs include: drain unclogging ($220), leaky faucet repair ($270), burst pipe repair ($400), toilet repair ($300), and water heater repair ($600). Note that these rates are for standard service hours; emergency, holiday, and after-hours calls will cost significantly more.

If you find moisture under your sink, you can clean up the worst of it with paper towels or regular towels. Then, leave the cabinet doors open to allow air circulation. You can also place a fan or dehumidifier near the cabinet to help dry it out a little quicker.

Try to tighten the clevis crew and adjust the lift rod if your sink stopper won’t stay up. Sometimes your screws became too loose over time, and as a result, there wasn’t enough resistance to keep the sink stopper up. If a damaged lift rod is the cause of the problem, you will need to replace it with a new rod.

Different plumbing problems can cause your P-trap to leak. The biggest problems are loose nuts and misaligned pipes. Over time, your P-trap can leak due to the rush of water moving through the pipes, which in turn loosens the nuts and causes the pipes to fall out of alignment. Other problems include worn rubber O-rings and cracked pipes.

A handyperson with basic plumbing experience can install a bathroom faucet, like the kind of skills you’d need to replace a P-trap or swap out a showerhead. They may not have deep knowledge of local plumbing code, though. If your faucet installation requires work on the pipes behind the wall or under the floor, hire a licensed plumber with the necessary training and licensing. 

The Latimer, MS homeowners’ guide to sink repair services

From average costs to expert advice, get all the answers you need to get your job done.