Get matched with top locksmiths in Houlka, MS

Begin by checking the power source, typically a battery or wired connection. Ensure the battery is installed correctly, has sufficient charge, and isn't corroded. If it's a wired lock, examine the electrical connections to confirm they are secure and free from damage. Additionally, inspect the lock's programming or settings. Confirm that user codes or access credentials are programmed correctly and that any remote control devices are paired and functional.

There are different types of deadbolts. The most common type is a single-cylinder deadbolt, which you may recognize on your front door. This type of lock has a keyhole on the outside and a thumb turn on the inside. A double-cylinder deadbolt has two locking mechanisms and requires a key to engage on the inside as well as the outside. 

When the temps drop, sometimes you need to thaw a lock to regain access. Options include warming the key with warm water, applying a de-icing spray, or using a hair dryer on low heat. Avoid using boiling water to prevent damage. To prevent future freezing, consider installing a cover or shield over the lock to keep water and ice out. Remember to be patient and gentle during thawing to avoid damaging the lock or key. If all else fails, consult a professional locksmith.

Expect to pay between $50 to $200 if you hire a locksmith to change your locks. That figure includes labor and the cost of basic hardware. The cost will naturally be higher if you plan to install more expensive locks, like smart locks, and if you need a lot of them.

Homeowners can save money by replacing locks themselves. A typical rekeying kit costs about $10 to $25. The only additional cost is purchasing new house keys, and those are no more than a few dollars per key. If you want to replace the locks on your own completely, the main cost is the price of the locks themselves. A standard knob-style lock starts around $25, while electronic locks and smart locks will run in the hundreds of dollars. The only additional tools you should need are a tape measure, screwdriver, and screws if they are not already provided.