Best pressure washers near Falkner, MS

On average, pressure washing a house can take anywhere from 30 minutes to three hours. The time frame to pressure wash or power wash your home, fence, or other property depends on the size of the project and the complexity and accessibility of the areas that need cleaning. Part of the time required to complete the job includes setup and removal of equipment needed. A two-story house with a steep roof may require working from scaffolding or a ladder, likely adding to the time required to finish the project. 

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.

You don't technically need to seal your driveway after pressure washing, but doing so will help keep your driveway clean for longer. The best driveway sealer depends on the type of driveway you have. To seal asphalt, consider an asphalt emulsion sealer, fast-drying sealer, or latex acrylic sealer. Concrete driveways commonly use acrylic sealers or penetrating sealers.

Yes, you can technically use a pressure washer to remove paint from brick, but it comes with a significant risk of damaging the brick surface. A high-power pressure washer can be fast but may leave the brick looking unsightly. The recommended method is to first apply a chemical paint stripper, following the product's instructions, and then use a stiff metal bristle brush or a pressure washer on a low-pressure setting to remove the loosened paint. Due to the risk of damage, it is often best to hire a professional who can use low-stress methods.