Get matched with top buffing and polishing pros in Diberville, MS

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

To clean stone tiles, first sweep or vacuum to remove dirt particles. Use a mild, pH-neutral detergent and warm water to mop. Be careful not to use acidic cleaning solutions, such as vinegar and lemon juice, which can damage the surface.

If you would rather use vinegar to clean the stone fireplace instead of dish soap, this mixture should work fine. Vinegar is slightly acidic, however, so it may etch some kinds of stone without quite a bit of diluting. For a stone fireplace, dilute it to about one cup of vinegar for every gallon of hot water. It’s a smart idea to test the diluted mixture in an inconspicuous area of the fireplace and watch for etching. You can use vinegar to clean quite a few different items around your home, and it’s especially good at removing stains.

The cost to polish floors averages around $200 per room, but you could pay anywhere from $100 to $300. Some factors that influence the total cost of floor polishing include the following:

• Square footage of flooring

• Type of floor 

• Whether you need floor repairs done beforehand

• Whether or not you want professional floor cleaning done beforehand

Since square footage is the most significant cost factor, you might get a more accurate estimate by using the average cost per square foot for floor polishing, which is between $1.00 and $2.50.