Get matched with top concrete driveway pros in Marshall, MO

You can whiten concrete for unsealed and unfinished concrete with a solution or either muriatic acid or bleach and water—but never both. However, if your concrete does have a stain, finish, or polish, keep in mind that these hard chemicals could damage the topcoat. Your best bet otherwise is to power wash outdoor concrete slabs or clean indoor ones with a gentle cleaner such as laundry or dish detergent.

Some homeowners have luck using pressure washers, but this only works for old or weaker concrete sealants and with very powerful pressure washers. You’ll get better results by pressure washing water-based sealants. However, it’s worth trying on any sealant if you’re hoping for the least toxic, least expensive, and most DIY-friendly option. To try this method, rent or buy the most powerful pressure washer you can find and take several passes at the concrete, completely pressure washing the entire area. You may need to repeat the process multiple times to see results.

The average cost to pressure wash a house is around $310, with typical prices ranging from $200 to $420. However, the total cost can vary widely, from $200 to $750. Power washing, which uses heated water, may cost between $250 and $400 per project, with an average of $200 to $300 for a 2,000-square-foot home.

Key factors that influence the final price include:

• The size and height of the house (a multi-level home costs more than a single-story one).

• The complexity of the job and accessibility of certain areas.

• Geographic location.

• Equipment and hourly labor costs.

Hiring a professional is often recommended as they bring their own equipment and cleaning solutions. Experienced professionals know how to complete the job effectively without causing damage to your siding, gutters, or landscaping, which can be a risk with high-powered water jets.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.