Get matched with top concrete driveway pros in Iberia, MO

The best cleaning solution for stamped concrete is a combination of water and mild soap. Dish soap and laundry detergent are good options. For more stubborn stains, you can use an alkaline cleaner that removes oil and grease. In either case, you’ll want to steer clear of abrasive cleaners and harsh chemicals which can damage the concrete.

Some homeowners have luck using pressure washers, but this only works for old or weaker concrete sealants and with very powerful pressure washers. You’ll get better results by pressure washing water-based sealants. However, it’s worth trying on any sealant if you’re hoping for the least toxic, least expensive, and most DIY-friendly option. To try this method, rent or buy the most powerful pressure washer you can find and take several passes at the concrete, completely pressure washing the entire area. You may need to repeat the process multiple times to see results.

Yes, you can and should pressure wash a stamped concrete driveway, as well as other stamped concrete around your yard on the patio or walkways. While the stamping pattern can handle the pressure of the water, it's still best to use a gentle solution to avoid breaking down the concrete or affecting any additional stain coloring added to the design.

Yes, you can pressure wash epoxy floors, but you must take precautions to avoid damaging the surface. While most epoxy floors can be cleaned with a mop, you might choose to pressure wash if the floor is stained, has ground-in dirt, or is covered with mold or mildew. To do so safely, first soak any stains or dirty areas with a gentle cleanser. Use a lower pressure setting with a gentle nozzle, such as a green, white, or black tip, or a 45-degree angled tip. Keep the spray nozzle at least 18 inches away from the floor to protect the surface. Using a surface cleaner attachment or a rotary scrubber can also help prevent overspray. Be cautious if using a power washer that heats the water, as the combination of heat and pressure may be too powerful and could damage the epoxy coating.