Get matched with top deck staining pros in Hayti, MO

Yes, it is generally a very good idea to seal your deck after pressure washing. Power washing removes not only dirt and debris but also a thin layer of wood, leaving the surface exposed and more susceptible to weathering. Sealing is almost always needed after this process. After a general cleaning, sealing isn't automatically necessary if the existing sealant is still intact. You can test the surface by placing a few drops of water on it. If the water beads up, the sealant is working. If it soaks into the wood, it's time to apply a new sealant. If it has been a few years, it's wise to remove the old sealant, wash the deck, and reseal for maximum protection.

Avoid using cleaning products that are abrasive or contain bleach or acidic components on composite decking to avoid discoloration. Early-generation Trex decking isn’t designed to handle pressure washer cleaning—and if you use them on second-generation boards, always use a low setting to avoid the risk of damage that can risk voiding your warranty.

Wood stain is typically dry to the touch within 6 to 12 hours, but it is not fully cured at this point. You should wait at least 24 hours before applying a second coat or a protective finish. For surfaces like decks, avoid walking on them for at least 24 to 48 hours, and wait even longer before placing furniture. The full curing process can take from 24 hours to one week, depending on the type of stain. Factors like high humidity and cold temperatures can extend drying and curing times, so it's wise to allow for extra time in these conditions.

Yes, you can and should paint or stain pressure-treated wood to help prevent the boards from cracking. However, you must wait for the wood to dry out completely before applying any finish. Freshly treated wood can take weeks or even months to dry; a common recommendation is to wait three to six months. To check if the wood is ready, perform a simple water test: drip some water onto the surface. If the water beads up, the wood is still too wet and needs more time to dry. If the wood absorbs the water, it is dry enough to be painted or stained. You can proceed with building your deck or fence while the wood is still wet, but you will need to wait to apply the paint or stain.