Top-rated concrete driveway pros.

Best concrete driveway pros near Crane, MO

Enter your zip and get matched with up to 5 pros

Need a pro for your concrete driveway service project in Crane, MO?

Select your specific project to find the pro for you.

Top-Rated Concrete driveway pros in Crane - Updated Nov 2026

NB Paving
4.1(
155
)
Asphalt Paving - Install

Serving Crane, MO and surrounding areas

Approved

In business since 1995

Free estimates

Warranties offered

"I recently had installed a hot-mix asphalt surface on my driveway. It encompassed approximately 550 feet in length. A good portion of that footage was a single 11-foot lane, but as it approached my home there is a circle drive with a landscaped area and differing widths of paving was needed, which required some rather intricate work. Also, part of the job encompassed paving up to the concrete area in front of my 3 car garage and to the sidewalk leading to the front of our home. Nelson Boswell and his crew of professional staff did an outstanding job of researching exactly what I was looking for, developed a plan for manicuring the existing gravel drive base, and applying the asphalt surface. They were extremely courteous, attentive to my needs above everything else, and did what they said they were going to do. They also were able to complete the whole project in a span of two days. At the end of the project, I thoroughly inspected the work, and do not have a single complaint. In fact, I would readily recommend them to anyone! Oh, and one other thing: they were very cognizant of my lawn and landscaping, going above and beyond to make sure nothing was disturbed."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+1

6 neighbors recently requested a quote
Recommended by86%of homeowners
Avatar for Stewart's Asphalt Paving
Stewart's Asphalt Paving
4.9(
20
)
Asphalt Paving - Install

Serving Crane, MO and surrounding areas

Approved

In business since 1980

Free estimates

Warranties offered

"The rains had washed the entrance to our driveway out and formed a large ditch. After almost a year of posting on some sites this company responded. They repaired and made a new entrance to our driveway. It looks wonderful. They were kind and professional. They got the job done. I give them 5 stars"
Tar and chip
Asphalt
Asphalt
Asphalt
Asphalt

+1

Response time3 days
5 neighbors recently requested a quote
Recommended by94%of homeowners
Dreamscapes
4.4(
18
)
Concrete Driveways - InstallConcrete Flatwork - Repair & ResurfaceConcrete Patios, Walks & Steps- Install+4 more

Serving Crane, MO and surrounding areas

Approved

In business since 2014

Free estimates

Emergency services offered

"They are our first call any time concrete work is needed at our business locale. Not only fair pricing, but utmost concern that we are happy with their work! They have re-done concrete porches, concrete steps and railings (welding) and most recently worked to refinish our concrete outdoor hot tub. Highly recommend!"
Stamped/Colored Driveway
Stamped/Colored Driveway
Stamp/Stain
Gunite Pool
Gunite Pool

+16

Response time3 days
25 neighbors recently requested a quote
Recommended by28%of homeowners
...
Showing 1-10 of 109
Concrete Driveways FAQs, answered by experts

You don't technically need to seal your driveway after pressure washing, but doing so will help keep your driveway clean for longer. The best driveway sealer depends on the type of driveway you have. To seal asphalt, consider an asphalt emulsion sealer, fast-drying sealer, or latex acrylic sealer. Concrete driveways commonly use acrylic sealers or penetrating sealers.

You should always power wash your driveway before applying a sealant. At any given time, your driveway could be covered with algae and moss, tire residue, oil and rust stains, and any combination of leaves, twigs, and dirt. If you skip power washing, you’ll be trapping the dirt and grime beneath the sealant and lowering its chance of cementing itself to your driveway. While you can expect the cost to pressure wash your driveway to average between $100 and $350, the few hundred dollars beats an unattractive driveway or paying extra to reapply your driveway sealer.

You can whiten concrete for unsealed and unfinished concrete with a solution or either muriatic acid or bleach and water—but never both. However, if your concrete does have a stain, finish, or polish, keep in mind that these hard chemicals could damage the topcoat. Your best bet otherwise is to power wash outdoor concrete slabs or clean indoor ones with a gentle cleaner such as laundry or dish detergent.

Whether you need to winterize your pressure washer depends on where it will be stored. If it's kept in a location where temperatures could drop to freezing, any liquid left in the water pump can freeze, expand, and cause severe damage to the machine. To prevent this, you can add antifreeze to the pump. While emptying the machine with compressed air is an alternative, it can be a tedious process and may not remove all the liquid. If you can store the pressure washer in a relatively warm place with no risk of freezing, you won't need to add antifreeze. However, regardless of storage conditions, it is good practice to empty the gas chamber and refresh the oil before storing it for the winter.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

The Crane, MO homeowners’ guide to concrete driveway services

From average costs to expert advice, get all the answers you need to get your job done.