Get matched with top affordable plumbers in Craig, MO

On average, a plumber will take 30 minutes to two hours to clear a clogged drain. If the clog is located close to the drain or an access point and isn’t severe, the project will take about half an hour. If the clog is deep within your plumbing system or is a severe blockage, it can take two or more hours to remove the clog. For this reason, main line clogs tend to take longer, usually between two and three hours.

Yes, frozen pipes can prevent a toilet from working correctly. If the pipes are frozen, water cannot flow, which means your toilet tank won't be able to refill after a flush. This will prevent the toilet from flushing again. Depending on which lines are frozen, the ice can also block the drain pipe, preventing water from flushing away.

As a temporary workaround, you can manually add water to the tank for each flush. To clear a frozen drain pipe, you can try filling the toilet bowl or tank with warm water and flushing to help thaw the ice. However, the best long-term solution is to unfreeze the pipes to get your toilet back in working order.

Yes, you can fix pipe threads. In fact, the process is the same as cutting new ones. You’ll need to use a pipe threader tool with the proper size die head for the pipe. Turning the threader over the damaged threads will clean up any damaged or worn-out threads in the pipe. If the pipe threads are too damaged, this process may not work, and you’ll need to replace the pipe.

A sewage ejector pump is necessary if you have any plumbing fixtures, such as a bathroom, laundry room, or sink, located below the level of your home's main sewer line. Standard plumbing relies on gravity to move wastewater and solid waste to the municipal sewer or septic tank. However, for fixtures located below grade (e.g., in a basement), gravity is not sufficient.

The purpose of a sewage ejector pump is to actively pump this wastewater and solid waste upward into the main sewer line. Without an ejector pump in this situation, wastewater would have no way to exit and would eventually back up, causing a sewage overflow or flooding in your basement. If all of your home's plumbing is on the main floor or higher, gravity can handle the drainage, and an ejector pump is not needed.