Get matched with top doorbell installation pros in Carl Junction, MO

If you need to insulate behind finished walls, the best option will likely be to have an insulation professional install blown-in insulation. The installation requires small holes cut in your wall, after which the installer can blow loose-fill insulation into the void. After the installation, you’ll have minor drywall patching, which shouldn’t cost more than $100. Compared to ripping down the existing drywall, using a different type of insulation, and replacing and finishing the drywall, this should save you hundreds or even thousands, depending on the size of the room you’re insulating.

For your safety, you should always wear a mask when cutting batts of fiberglass insulation. We also recommend wearing eye protection, safety gloves, and long sleeves to protect your skin. Properly suiting up helps you avoid several fiberglass issues, such as cuts from the tiny shards of glass and inhaling small bits of fiberglass.

R-30 insulation is better for higher thermal resistance, but whether it’s "better" depends on the application. R-30 is much thicker and suited for areas like attics or floors in cold climates, where more insulation is required. R-13, on the other hand, is thinner and works well for 2x4 walls or milder climates where less insulation is sufficient. Choosing between R-13 and R-30 depends on the area being insulated and the climate. For example, R-30 provides more insulation but may not fit everywhere in your home.

Ideally, you can add new insulation to your existing insulation. However, some circumstances require you to remove old insulation before adding any new insulation: 

• If the insulation is over 15 years old

• If the insulation is wet or moldy

• If it is vermiculite insulation

• If you see signs of pest infestation

Removing old insulation is best left to a pro who can safely dispose of potential moldy or asbestos-ridden insulation.