Top-rated water heater pros.

Get matched with top water heater pros in Pipestone, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your water heater service project in Pipestone, MN?

Select your specific project to find the pro for you.

Verified Reviews for Water Heater Service pros in Pipestone, MN

*The Angi rating for Water Heater Service companies in Pipestone, MN is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Water Heater Service needs.

*The HomeAdvisor rating for Water Heater Service companies in Pipestone, MN is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Water Heater Service needs.

Last update on March 11, 2026

Find Water heater pros in Pipestone

Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Solar Water Heater System - InstallTankless Water Heater - InstallTankless Water Heater - Install - For Business+6 more

Serving Pipestone, MN and surrounding areas

In business since 1971

Credit card accepted

"We pay yearly but we have this is included with our rental property. They are pretty good on most things. We had a hot water heater replaced and they did an excellent job on that. They are very quick on their response. They dont come out here. It is all done on the internet.  I just like the idea that one time service charge is so much better than trying to hiring someone to come in. It is more about convenience. It pays for itself."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Request Quote
Water Heaters questions, answered by experts

The standard copper wire gauge to use with any 30-amp circuit is a 10-gauge wire. The National Electric Code specifies a 10-gauge wire with appliances like water heaters running on 30 amps. If you try to use a smaller gauge wire, such as a 12 gauge, with a 30-amp breaker, you run the risk of the wire overheating and melting or causing a fire. Because of the safety hazards, the gauge of the wire is not an area to try to cut costs when connecting a 30-amp breaker to a water heater.

Yes, most municipalities have codes that require water heaters to have pans. A pan is necessary when a water heater or hot water storage tank is installed in an area where water leakage could cause damage, such as an attic, second floor, or finished basement. Tankless water heaters are not required to have a pan since there is no storage tank.

The average water heater holds between 40 and 60 gallons, but the exact amount of water that comes out during draining will depend on your unit’s capacity. The amount of time it takes to drain a water heater averages from 10 to 30 minutes.

No. Expansion tanks must be installed on the supply side (where heated water flows out) of the boiler. There’s also a list of other requirements for most boilers, including being above the pressure relief valves, being on the inner side of any circulator, and more. Your installation manual should have more information on expansion tank installation requirements and what sort of tank the system is made for.

Tankless water heaters heat water as it passes through the unit instead of storing heated water in the tank. Their ability to produce hot water on an as-needed basis makes them more efficient. However, they are generally more expensive than traditional units. Is a tankless water heater worth it? Most homeowners will save money with a tankless unit in the long run by using less energy.

The Pipestone, MN homeowners’ guide to water heater services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles