Top-rated stucco pros.

Get matched with top stucco pros in Ellsworth, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your stucco service project in Ellsworth, MN?

Select your specific project to find the pro for you.

Find Stucco pros in Ellsworth

Avatar for R & V Residential Contractors LLC
R & V Residential Contractors LLC
4.9(
7
)
Traditional Stucco - Repair or Partially Replace

Serving Ellsworth, MN and surrounding areas

In business since 2021

Free estimates

Credit card accepted

"They did excellent work. Very careful to install correctly, caulk and trim cleanly and precisely. Cleaned up inside and outside. They worked so hard to make sure everything looked nice. Very impressed. We had 11 windows done."
Response time1 day
Response rate86%
Recommended by50%of homeowners
Stucco questions, answered by experts

The length of time shouldn’t matter much if you stick with lightweight Christmas lights and similar decorations. Those shouldn’t pose risks to your stucco. You should avoid attaching anything to your stucco that could fall because it’s too heavy, which may take part of the stucco with it. Some methods, like using double-sided tape or adhesive hooks, will naturally wear out over time and lead to falling lights, so don’t expect to leave these lights up year-round.

The best way to assess that your stucco needs repair is to inspect it, both visually and physically. If you notice cracks, chips, or staining, that’s a good indication that your stucco could use some TLC by a professional. Additionally, if you touch an area that feels soft and has a little “give,” you should consider repairing it as soon as possible to avoid further damage, both to additional stucco spots and to your home’s structure. 

Yes, you can apply the stucco yourself, but it is a time- and labor-intensive project, especially on the exterior of a whole house. DIY stucco is better suited for repairing stucco siding or siding a smaller building, such as a shed or garage. Since most of the cost of stucco siding goes to labor, you can cut down significantly on the total if you’re up for the challenge.

Yes, using natural additives and methods that lower impact.

You can use small bits that are up to 3/8 inch in diameter, or larger bits that are 1/2 inch or more in diameter. Make sure the bits you use are coated with carbide or diamond; this information is usually visible on the package. You can also use hole saw bits to drill into stucco.

The Ellsworth, MN homeowners’ guide to stucco services

From average costs to expert advice, get all the answers you need to get your job done.