Get matched with top stucco pros in Caledonia, MN

You can use small bits that are up to 3/8 inch in diameter, or larger bits that are 1/2 inch or more in diameter. Make sure the bits you use are coated with carbide or diamond; this information is usually visible on the package. You can also use hole saw bits to drill into stucco.

Yes, you can screw directly into stucco. Only do so if the item you are installing is a permanent fixture. Drill a pilot hole into the stucco using a masonry or concrete bit, then drive in the screw with a power drill or screwdriver.

When cleaning stucco siding, it is recommended to use a pressure washer with a psi (pounds per square inch) between 1,500 and 2,000. This range provides sufficient power to remove dirt and grime without causing damage to the stucco surface. It's important to avoid using excessive psi as it can chip or crack the stucco. 

Using a wider spray nozzle and keeping a safe distance of about seven to 10 feet from the siding helps ensure a gentle and effective cleaning process. Always follow the manufacturer's guidelines and adjust the psi accordingly based on the condition of your stucco and the specific requirements of your pressure washer.

The length of time shouldn’t matter much if you stick with lightweight Christmas lights and similar decorations. Those shouldn’t pose risks to your stucco. You should avoid attaching anything to your stucco that could fall because it’s too heavy, which may take part of the stucco with it. Some methods, like using double-sided tape or adhesive hooks, will naturally wear out over time and lead to falling lights, so don’t expect to leave these lights up year-round.