Top-rated epoxy flooring pros.

Get matched with top epoxy flooring pros in Brewster, MN

Enter your zip and get matched with up to 5 pros

Need a pro for your epoxy flooring service project in Brewster, MN?

Select your specific project to find the pro for you.

Find Epoxy flooring pros in Brewster

Avatar for Mark Betker Construction, LLC -
Mark Betker Construction, LLC -
0.0(
1
)
Concrete Floor Coating-ApplyConcrete Floor Coating-Apply - For Business

Serving Brewster, MN and surrounding areas

In business since 2004

Free estimates

Warranties offered

Concrete Coating Solutions specializes in both residential and commercial epoxy flooring, polyurea (polyasparatic), polished concrete, and commercial shop floors including cove, with a proud portfolio of over a decade. We offer the highest quality professionally installed epoxy flooring in the industry today. So, whether you are looking for protective, durable, seamless, stylish, chemical resistant,high MVE resistance, elegant or tough flooring Concrete Coating Solutions is the company to rely on. \nEpoxy Flooring at it��s Finest\n Concrete Coating Solutions, LLC takes pride in using an application of coatings that will not contaminate order-sensitive products. Our products comply with VOC regulations, LA rule 66 and meet USDA approved guidelines.\n

Before
After
Before
After
After

+24

Recommended by100%of homeowners
Avatar for Matthew Moss Painting
Matthew Moss Painting
3.7(
3
)
Concrete Finishing, Overlays & Coloring - Apply

Serving Brewster, MN and surrounding areas

In business since 1990

Emergency services offered

Credit card accepted

"Well it took some time for them to get out there because we had lots of rain that week, but when they showed up, they were great, I cant believe they even took the time to do a little shed for me that was not even in the quote, and did not charge me for it, they said they felt bad because the rain kept delaying them but that was not there fault, wow what a professional company, you don't see guys like Mr. Moss anymore you could tell his work is very important to him....."
Additional Photos
Additional Photos
Before
After
Before

+24

Recommended by66%of homeowners
Epoxy Flooring questions, answered by experts

As with anything you buy, be wary of prices that seem too good to be true. Some low-cost flooring products can contain chemicals that release harmful VOCs (volatile organic compounds) in the form of fumes that can be inhaled or dust that can cause skin conditions.

Even good-quality products can be dangerous for DIY-ers who don’t take proper precautions. Always carefully read manufacturer instructions and wear the recommended protective gear when working with paints and other chemicals. You can also hire a local garage flooring pro with the experience and equipment needed to perform the installation safely with no lingering fumes or debris.

The biggest downside of sealing concrete is that it needs to be resealed every few years. This routine maintenance can be laborious if you do it yourself and expensive if you hire a professional. Beyond that, sealing concrete can make the surface slippery, which can be dangerous with people with mobility issues, young children, or those with pools near their patios.

You primarily need to be concerned about the moisture level in concrete when you are dealing with a basement or other below-ground part of your house. If you find any indication of moisture in your subterranean space, consider calling in a professional for further testing and moisture control solutions.

Yes, you can seal old or existing concrete, but proper preparation is crucial. The concrete surface must be clean, dry, and free of any incompatible old sealant. To check if an old sealer is present, drip a few drops of water onto the surface; if the water is absorbed in under five minutes, it's ready to be resealed. If you plan to use the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are using a different type of sealer, the old one must be completely removed. Before applying the new sealer, thoroughly clean the concrete and repair or fill any cracks to ensure a smooth, well-prepared surface.

You can whiten concrete for unsealed and unfinished concrete with a solution or either muriatic acid or bleach and water—but never both. However, if your concrete does have a stain, finish, or polish, keep in mind that these hard chemicals could damage the topcoat. Your best bet otherwise is to power wash outdoor concrete slabs or clean indoor ones with a gentle cleaner such as laundry or dish detergent.

The Brewster, MN homeowners’ guide to epoxy flooring services

From average costs to expert advice, get all the answers you need to get your job done.