Best marble restoration pros near Roscommon, MI

Due to the acidity, using vinegar to clean quartz countertops can actually damage them. In fact, doing so can cause discoloration and surface damage in the quartz. While it’s possible to clean other countertops, like laminate, tile, and butcher block, with vinegar, it’s best to stay from this cleaning solution if you have quartz in your kitchen or bathroom.

You most likely purchased a quartz countertop because it won't stain or etch like marble. However, etching can still happen depending on the quality of the quartz and whether it is repeatedly cleaned with harsh chemicals or exposed to acidic spills. Remember, while quartz is more resistant than natural stone, just like Superman when faced with Kryptonite, it is not indestructible.

Overall, granite tends to cost more than marble. Prices for each material will fluctuate depending on the source of the stone, your location, shipping costs, and the thickness of the material. Labor to install marble or granite countertops typically ranges from $35 to $45 per hour. Granite and marble tile and slab costs compare as follows:

• Marble tile: $7–$10

• Granite tile: $5–$15

• Marble slab: $25–$60

• Granite slab: $50–$100

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.