Get matched with top electricians in Coopersville, MI

Yes, electricians must be licensed, certified, and in most cases, insured. Licensing requirements vary by state and local municipality, but most U.S. municipalities require electricians to hold an electrical contractor’s license. It's always a good practice to confirm requirements with your local municipality. Even if licensing is not required in your area, hiring a licensed and experienced electrician often leads to a better end result.

A license is a legal requirement to operate a business and is necessary for pulling project permits. Certifications, on the other hand, are typically voluntary and demonstrate a certain level of expertise. In some cases, a certified electrician may send an apprentice or journeyman to perform the work, but they must operate under a primary electrician who holds the proper license.

Before hiring, you should verify the electrician's license, insurance coverage, and any third-party certifications. You can use Angi’s contractor licensing search to confirm a pro's license status. Additionally, businesses with the “Angi Approved” badge on our platform meet strict criteria, including having the required state and local licenses, passing a background check, and maintaining a high average rating.

No. When applied properly, electrical tape is designed to be an insulating material with high resistance to electricity. It can reinforce electrical connections and act as a safeguard to help ensure the electrical current stays within its designated pathways. However, it’s important to note that it can break down over time and you should never use it as a replacement for electrical wire caps.

You can determine what size generator you need for a transfer switch by matching the switch to the largest outlet on your generator. Larger generators can power up to 10 circuits, while most 5,000-watt generators can provide power to six circuits. So, if your generator’s largest outlet is 30 amps, you’ll need a 30-amp transfer switch.

The National Fire Protection Association reports that almost half of reported electrical fires are caused by electrical distribution and lighting equipment. The main culprit behind these fires is often frayed, worn, or faulty wiring, particularly in closed-off and concealed areas like attics, where fires can start and burn undetected for long periods.