Top-rated well and pump technicians.

Get matched with top well and pump technicians in Applegate, MI

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Applegate, MI?

Select your specific project to find the pro for you.

Find Well and pump technicians in Applegate

Metamora Water Service, Inc.
4.7(
163
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Applegate, MI and surrounding areas

In business since 1991

Free estimates

Emergency services offered

"I had a well pump that needed to be replaced, but was rusted in and after two weeks of work from Shawn's employees the pump could not be removed. With their help was able to hire a company capable of digging new well in confined space and getting all the proper paperwork started. I was very please with all employees that I was in contact with and appreciate their help and understanding of my lack of knowledge. Good work everyone."
Recommended by97%of homeowners
Avatar for Stay Dry Basement Waterproofing Inc
Stay Dry Basement Waterproofing Inc
4.5(
221
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Applegate, MI and surrounding areas

In business since 2006

Free estimates

Emergency services offered

"My pump died on me around 8:00 p.m. one night and Staydry sent someone right over the same night and had the pump replaced in 30 minutes and I haven’t had any issues since. I will definitely call them for any further issues I have with my basement."
French drain
French drain
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by89%of homeowners
Avatar for Choice Home Warranty
Choice Home Warranty
4.0(
5,678
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Applegate, MI and surrounding areas

In business since 2008

Emergency services offered

Credit card accepted

"Went well to this point of replacing parts. Then the United needed to have a system leak test and then needed freon put in pump. This was refused by Choice warranty. We were left with a partial repair and a heat pump not able to do it's job."
Recommended by81%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Applegate, MI and surrounding areas

In business since 1971

Credit card accepted

"Rather than fix the issue the first 2 calls, more refrigerant was pumped into the system. This cost me $75 for each call plus the cost of the refrigerant. The 3rd time, they fixed a valve and refilled the refrigerant and I am monitoring to see if this really fixed the problem. So I am out $225 for service calls fro the same problem and the cost of the refrigerant. I think they take this approach intentionally."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
Wells and Pumps questions, answered by experts

If you have a self-cleaning washing machine but you’re still seeing lint, your water pump filter might be clogged. To clean it, you should unscrew the drain hose, then remove the water pump filter. From there, you can inspect it and clean it with warm water before replacing it. Check to be sure your washing machine is functioning by running a short cycle. 

There are many signs to look for that will tell you when your irrigation pump is burned out. This may include low water pressure, sprinklers that sputter a lot before turning on, discolored or dirty water, or a pump that stops working altogether. If your pump has any of these issues, it is probably time to replace it.

A submersible pump should be at least 10 feet from the bottom of the well to minimize the risk of the pump drawing debris into the well water. Submersible pumps work best for wells that are 25 feet deep or less. If you have a deeper well, choose a jet pump instead of a submersible model.

Well pump repair might be covered by your homeowner’s insurance, but it’s typically not. If the damage results from a major storm in your area, flooding, a fire, or some other natural catastrophe, then you should consider filing a claim for the damage. However, if the issue is the result of an aging well pump, your policy will very likely not cover the repair cost. In either case, you should hire a well pump professional inspect your well pump, and then use that information to decide whether or not you should file a claim.

The pressure in a well pressure tank should be set 2 to 3 PSI below the pump's cut-on pressure. The cut-on pressure is the lower number in the pressure setting (e.g., the '30' in 30/50 PSI) and is the point at which the pump starts. The cut-out pressure is the higher number, where the pump stops.

For example:

  • If your pressure switch is set to 30/50 PSI, the tank pressure should be 27-28 PSI.

  • If your pressure switch is set to 40/60 PSI, the tank pressure should be 38 PSI.

Common pressure settings for household applications include 20/40, 30/50, and 40/60 PSI. The difference between the cut-on and cut-out pressure is typically 20 PSI.

The Applegate, MI homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.