Get matched with top insulation pros in Easton, ME

The most affordable way to insulate behind unfinished walls is to install fiberglass batts or rolls. These total around $0.75 per linear foot, with the width matching the gaps between standard studs perfectly. However, it’s important to consider the R-value of your insulation and the climate in your area, as fiberglass insulation isn’t the best in terms of preventing heat transfer. Plus, the most affordable option may cost more on electricity bills over time. The most affordable way to insulate behind finished walls is to leave them up and use blown-in insulation to avoid drywall replacement.

While adding insulation can be beneficial, there is too much of a good thing. Too much insulation can seal your house to the point where it can't release moisture that enters it—essentially trapping water vapor inside. Warm, humid climates are extra susceptible to mold from moisture issues, but homes in colder climates can experience condensation from an air-tight home when freezing temperatures thaw.

R-value stands for resistance value and is a number assigned to insulation that states how good the insulation is at heat transference (insulation). The R-value of injection foam is around 4 which homeowners will be happy to know is actually quite good. Another benefit of injection foam versus fiberglass foam is that the colder it gets, the more injection foam retains its resistance properties, whereas fiberglass tends to lose its efficiency in colder temperatures.

There are many reasons one bedroom may be hotter than the rest of the house. The sun will quickly heat a south-facing bedroom with a large window, especially if it lacks quality curtains. If the room has poor insulation, this could let more warm outside air in. Upstairs bedrooms are often hotter than ground-floor rooms because heat rises. Finally, rooms further away from the air conditioning unit may heat up a lot if the system is not properly balanced.