Top-rated above ground pool installation pros.

Get matched with top above ground pool installation pros in Rawlings, MD

Enter your zip and get matched with up to 5 pros

Need a pro for your above ground pool installation project in Rawlings, MD?

Select your specific project to find the pro for you.

Find Above ground pool installation pros in Rawlings

Install Above Ground Pools questions, answered by experts

An above-ground pool with a deck can increase your home's value by as much as 4% to 7%, but it depends on your local climate, potential buyers, and the size and condition of your pool. Some buyers see a pool as a liability instead of a luxury, especially if it's at the end of its life span. In general, it's best to add a pool and deck to your property if it will bring you enjoyment—not because it raises the value of your home.

The type of sand you need for your sand filter depends on the manufacturer’s instructions, but you’ll need to use sand specifically for pool filters. Silica sand is a wallet-friendly, common choice that’s relatively easy to replace. You’ll choose between various grades of sand and different-sized sand grains.

Figuring out how to clear a green pool can seem tricky at first, but it’s all about knowing which pool cleaning chemicals to use. You may think of using baking soda to help you with your algae problem, but unfortunately, it won’t help. This is because baking soda only raises your pH and alkalinity levels. 

Instead, you need to use pool shock to clear up a green pool—the shock raises the free chlorine levels and will kill the algae.

You can check if your pool is bonded by looking for a copper wire that connects to the motor and pumps and then extends into the ground. However, if you’re unfamiliar with electrical wiring, contacting a pool electrician to inspect the motor and pumps is safest. An electrician can check the system and determine if it is up to code and meets all swimming pool bonding requirements.

Any number between 7.2 and 7.8 is an ideal pH for swimming pools or 80 to 120 ppm. Your pool testing kit should be able to measure both of these numbers. If your pool’s pH is below this range, the water is too acidic and can cause scaling and damage to pool equipment. If the water’s pH is above this range, it can decrease the effectiveness of necessary chemicals, like chlorine.

The Rawlings, MD homeowners’ guide to above ground pool installation services

From average costs to expert advice, get all the answers you need to get your job done.