Get matched with top pool and spa technicians in Hebron, MD

Most hot tubs will experience leaks due to wear and tear in the plumbing or the shell itself. The second most common issue is a heater malfunction due to the ongoing heat stress on moving parts. Finally, clogs happen in hot tub jets, especially when it’s time to change the filter.

Hot tub repairs cost between $200 and $500 on average. You can minimize those costs by maintaining your hot tub and keeping necessary supplies on hand. An elevated shelf in the garage is a great place to store your water care chemicals so that kids and pets will stay safe and you’ll always have them around. 

Your hot tub should be drained of existing water, cleaned, and refilled every three to four months at a minimum. Follow your tub manufacturer’s recommendations for cleaning, and rinse thoroughly when finished to eliminate any residue from the cleaning products. This is also a good time to inspect your tub’s cover in good lighting for any leaks, tears, or other damage that might cause problems. 

Using your hot tub manufacturer’s suggested cleaners and methods, keep your hot tub filters clean to avoid a loss of water heat. This will help extend the filter’s useful life and efficiency. If the filter is more than two to three years old, replace it with a new one and buy a second filter to keep around as a spare.

Yes. If you test the water and the alkalinity is too low, you can raise it by adding an alkalinity increaser, which likely came with your hot tub’s chemical kit. In a pinch, you can use baking soda to raise the hot tub’s alkalinity. Raising the alkalinity will prevent the hot tub water from becoming too acidic.

You can and should use a hose to fill a hot tub. There shouldn’t be anything special about the hose other than it shouldn’t be damaged. Kinks or leaks could slow down the filling process. Attach the hose to the nearest spigot and get the water flowing.