Top-rated contractors.

Get matched with top contractors in Galliano, LA

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Galliano, LA?

Select your specific project to find the pro for you.

Find Contractors in Galliano

Avatar for Homemade Design
Homemade Design
3.7(
322
)
Major Home Repairs (General Contractor)

Serving Galliano, LA and surrounding areas

In business since 2006

Credit card accepted

"I never contacted the provider or used this service in anyway. I have to
write this review so that the request to write this review stops
popping up.
The rating is bogus as it is required to be able to submit.
"
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Avatar for Jill Seidner Interior Design
Jill Seidner Interior Design
3.5(
89
)
Major Home Repairs (General Contractor)

Serving Galliano, LA and surrounding areas

In business since 2006

Credit card accepted

"Once I sent her all the measurements, it took her a little while to get the options back to me.  Overall, they're good designs.  However, they're very simplistic and give general ideas for space planning.  I was hoping to have a better idea for sizes of furniture for the space and some variations on staging.  
Jill was very responsive when I did have a question.  I'm not sure how helpful it is to have a virtual design done.  If we lived in similar cities, I'd probably use her again for help with additional designs.
"
Recommended by55%of homeowners
Avatar for All in one nationwide
All in one nationwide
5.0(
5
)
Major Home Repairs (General Contractor)

Serving Galliano, LA and surrounding areas

In business since 2022

Free estimates

Credit card accepted

"Henry and his crew were here right as scheduled. They went right to work and got the job done in less than a day. Their clean up of the job site was wonderful!! I would definitely recommend this company."
Roofing
Double ridge cap
Roofing
Roofing
Roofing

+7

Recommended by100%of homeowners
Avatar for Stone Wood And Tile
Stone Wood And Tile
5.0(
2
)
Major Home Repairs (General Contractor)

Serving Galliano, LA and surrounding areas

In business since 2010

Free estimates

Emergency services offered

"Other than a late start the team was focused and knowledgeable. They took great care to cleanly remove the damaged flooring and professionally install the replacement. It should be notes that the old flooring was incorrectly glued, making the task very tedious and difficult. The result is that you can't tell where the repair is without knowing its location. Well done."
Scarlet Pearl Casino
Scarlet Pearl Casino
Scarlet Pearl Casino
Scarlet Pearl Casino
Scarlet Pearl Casino

+6

Recommended by100%of homeowners
Showing 1-10 of 30
Unfinished Carpentry questions, answered by experts

Metal stud framing parts include the studs themselves, upper and lower tracks that act as top and bottom wall plates, various angle fasteners and clips, screws for fastening pieces togeher, metal straps, c-channel supports, and thicker steel supporting structures. Roof framing metal components include pre-fabricated trusses, heavy-gauge stud pieces, and various plates and fasteners.

To calculate the number of linear feet of baseboard you’ll need, measure the length of each wall of the room you’re installing them in as close to the floor as possible, rounding up to the next full linear foot. If it’s your first DIY molding job, having a few extra feet on hand for miscuts is a good idea.

Yes, a 2x6 should hold a porch swing and safely support the load. A smaller joist runs the risk of it not offering enough support for the swing. If you have a joist smaller than 2x6, add additional bolstering support.

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

Framing a house with steel generally takes less time—around five to eight weeks—than most building materials. The steel components can also be made quickly off-site and manufactured with pre-punched holes for running piping and electrical wiring, which will lessen the prep work and extra labor during construction.

The Galliano, LA homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.