Best concrete driveway pros near Edgard, LA

When comparing installation costs, asphalt is often less expensive upfront than concrete. Asphalt prices typically range from $7 to $15 per square foot, while concrete can range from $3 to $18 per square foot. However, long-term costs should also be considered. Concrete driveways generally last longer (up to twice as long) and require less maintenance, which can make them more affordable over their lifespan. While asphalt has a lower installation cost and is easier to repair, it requires more frequent maintenance, such as sealing, which can add up over time. Therefore, while concrete is more expensive initially, its durability may offset the cost in the long run.

There’s no legal requirement that states that you need rebar in a concrete driveway, but since the slab will be supporting heavy vehicle loads, it’s always a good idea to pay a bit more for rebar reinforcement. Your driveway will be much more likely to crack if you don’t reinforce it with rebar. Driveways that need to support commercial vehicles or provide parking for multiple vehicles at once should always include rebar reinforcement. If you’re pouring concrete over asphalt or pouring concrete over an existing slab, you may not have enough depth for rebar, meaning an increased risk of cracking.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.

A pressure washer’s size or power is measured in pounds per square inch (PSI). The amount of pressure you need will depend on your project and the material you’re washing, but consumer pressure washers range from 500 to 2,400 PSI. Porous materials like brick and stucco should not be blasted with anything stronger than 1,000 PSI, while you can use a PSI of up to 2,400 to clean a vinyl fence.