Top-rated contractors.

Best contractors near Deridder, LA

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Deridder, LA?

Select your specific project to find the pro for you.

Top-Rated Contractors in Deridder - Updated Nov 2026

Avatar for Homemade Design
Homemade Design
3.7(
322
)
Major Home Repairs (General Contractor)

Serving Deridder, LA and surrounding areas

In business since 2006

Credit card accepted

"I never contacted the provider or used this service in anyway. I have to
write this review so that the request to write this review stops
popping up.
The rating is bogus as it is required to be able to submit.
"
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Avatar for Jill Seidner Interior Design
Jill Seidner Interior Design
3.5(
89
)
Major Home Repairs (General Contractor)

Serving Deridder, LA and surrounding areas

In business since 2006

Credit card accepted

"Once I sent her all the measurements, it took her a little while to get the options back to me.  Overall, they're good designs.  However, they're very simplistic and give general ideas for space planning.  I was hoping to have a better idea for sizes of furniture for the space and some variations on staging.  
Jill was very responsive when I did have a question.  I'm not sure how helpful it is to have a virtual design done.  If we lived in similar cities, I'd probably use her again for help with additional designs.
"
Recommended by55%of homeowners
Deridder Construction & Handyman services LLC
5.0(
7
)
Major Home Repairs (General Contractor)

Serving Deridder, LA and surrounding areas

"I called Mr. Rainwater to inspect our roof after noticing leaking after a recent severe thunderstorm. He was able to meet with me the same day I called. During the consult he inspected the roof and took pictures of all the issues he found. Mr. Rainwater sat down with me to explain the findings and why they needed to be addressed. He was very knowledgeable about the work that needed to be completed. Overall I was very satisfied with the initial consultation. We scheduled him to address the problems with our roof. I am happy with the work Mr. Rainwater completed on our roof and the information on roof maintenance he told me to keep track of. I would highly recommend DeRidder Construction and Handyman Service LLC for any house care, repair and maintenance. Great company!"
Recommended by100%of homeowners
Showing 1-10 of 50
Unfinished Carpentry FAQs, answered by experts

Most of the time, you’ll want to use screws on your subfloor rather than nails. Nails can actually weaken plywood, whereas screws can easily penetrate without damage. They also form a more secure connection because of their shape, preventing squeaky floors and tightly holding the subfloor in place. That said, some contractors do prefer nails depending on the type of floor covering because they allow for more flexibility.

It's possible to turn your carport into a living space, but there are additional factors to address over turning it into a garage. HVAC, plumbing, and electricity won't be optional, and you'll need finished flooring, drywall, trim work, and legal ceiling height, for starters. Also, keep in mind that living space conversions may require upgrading the foundation underneath, and the permits might be more expensive as well.

It’s best to use two screws to secure deck boards into every joist. Securing the boards to every joist makes the deck more structurally sound, while using two screws on the outer sides of the boards can help prevent warping and cupping.

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

Joists do distribute their load to beams, but they don’t sit on top of the beams. Instead, home builders nail or screw the joists directly to the beams such that the end of the joist butts up against the edge of the beam. Beams can sit on other beams for support, but you’ll never see a joist sitting on top of a beam or another joist.

The Deridder, LA homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.