Top-rated concrete cutting pros.

Get matched with top concrete cutting pros in Grayson, KY

Enter your zip and get matched with up to 5 pros

Need a pro for your concrete cutting project in Grayson, KY?

Select your specific project to find the pro for you.

Find Concrete cutting pros in Grayson

Avatar for A&K Power Washing LLC
A&K Power Washing LLC
4.7(
26
)

Serving Grayson, KY and surrounding areas

In business since 2012

Emergency services offered

Credit card accepted

"The crew was so polite . The project looks great! No matter what I asked them to do they acomplished the task. My house was damaged by woodpeckers and they had to repair that damage before they could start. All suggestions by Anthony and Karen were wonderful. My house looks brand new!!! "You get what you pay for.""
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+29

Recommended by95%of homeowners
Avatar for KC Form and Finish
KC Form and Finish
3.8(
8
)

Serving Grayson, KY and surrounding areas

In business since 2020

Free estimates

Emergency services offered

"KC Forms and Finish were great to work with! The work was done in a timely manner, the cost was reasonable, and the customer service was great! The jobs finish was straight and the design was seen throughout the driveway. Would highly recommend them!"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+1

Recommended by83%of homeowners
Showing 1-10 of 29
Concrete Cutting questions, answered by experts

Professional metal fabricators typically charge around $70 per hour, but the total cost of your project will depend on several factors. The largest cost drivers are the size, complexity, and design of the project, as well as the price and type of metal used. A good way to estimate the total cost is to multiply the cost of raw materials by four; typically, one-quarter of the total goes toward materials and three-quarters toward labor. Your geographic location can also influence costs, as labor and material prices vary by region.

Yes, you can use a saw to cut metal pipes. The best saw to use is a reciprocating saw, but even a fine-tooth hacksaw can get the job done. No matter which saw you use to cut metal pipes, wear protective gear, like work gloves, safety goggles, and ear plugs. Apply a firm, steady pressure to the tool, and always ensure the pipes are secured so they don't move while you make the cuts.

Yes, but you’ll need reliable steel-cutting tools and safety gear to get started. Shipping containers are typically around ¾ inch thick, so it’s entirely possible to cut through them, but experience and the right equipment are very important. When possible, try to get a container as close to the size you want it as possible.

While a high-speed circular saw will cut through metal, and even cut through multiple sheets at once, the fast-spinning saw blades create a lot of heat. This heat can damage paint and other protective coatings, leading to serious problems like rust over time. The cost to paint a metal roof again to avoid this damage is typically an additional $0.50 to $1 per square foot.

Since water heaters are primarily made of metal, they’re commonly accepted by scrap yards and collectors. Don’t expect to fetch a high price, though—water heaters are mostly steel and aluminum, which aren’t high-value metals. Some components are made of more valuable metals, like brass and copper, but they’re a small portion of the heater and won’t affect the price much.

The Grayson, KY homeowners’ guide to concrete cutting services

From average costs to expert advice, get all the answers you need to get your job done.