Top-rated floor polishers.

Best floor polishers near Meade, KS

Enter your zip and get matched with up to 5 pros

Need a pro for your floor polishing project in Meade, KS?

Select your specific project to find the pro for you.

Top-Rated Floor polishers in Meade - Updated Nov 2026

Floor Polishers FAQs, answered by experts

Professionals use various tools and cleaning solutions based on the type of floor they’re cleaning. They often use industrial steam cleaners to pull debris out of the carpet. For localized stains, they may use a commercial cleaner or a mixture of water, vinegar, and dish soap. For tile, they’ll typically use dish soap and hot water, plus a mixture of baking soda and hot water for the grout. For cleaning wood floors, they might use a low-heat steamer, a mop with an oil wood floor cleaner, or a mixture of hot water, vinegar, and lemon juice.

Most DIY floor cleaners don’t require rinsing, but you’ll want to make sure you don’t add too much dish soap or oil to the cleaner to avoid having to rinse it after cleaning. For non-wood floors, mix 8 parts warm water, 1 part vinegar, and 1 part baking soda with a few drops of dish soap. For wood floors, use olive oil in that same mixture instead of the vinegar. You can let these solutions air-dry after cleaning your floors with them, although you should manually dry your floors if they aren’t waterproof.

The best solution for mopping floors depends on the type of floor you have, but a good all-around or multi-purpose DIY floor cleaner is 2 cups of warm water, 5 to 10 drops of liquid dish soap, and 1 tablespoon of lemon juice. This is safe to use on tile, laminate, wood, polished concrete, vinyl, and more, as it’s relatively neutral and lacks caustic and abrasive chemicals that could be harmful to children and pets. You can also use a multi-purpose commercial cleaner, but make sure to follow the directions for safety.

Yes, but with caution. A floor grinder is intended to level and polish concrete, so it is a very powerful tool. To remove paint, the floor grinder should be set to 35 square feet per minute or less to minimize the pressure without the use of pocket weights. You might need to go over the surface two times to get any paint that has sunk into the concrete’s pores.

Using too much soap or floor cleaner can leave your laminate floors looking dirty or cloudy after mopping. Only use a teaspoon of soap or cleaning solution in a gallon of water. Additionally, always be sure to sweep or vacuum laminate floors before mopping to ensure you pick up dried grit, hair, and dust that can be harder to catch with a wet mop.

The Meade, KS homeowners’ guide to floor polishing services

From average costs to expert advice, get all the answers you need to get your job done.