Get matched with top floor polishers in Haven, KS

Steam mops can be a better option than traditional mops because the steam can lift stubborn dirt from floors without using chemicals, and it also kills bacteria and dust mites. However, steam mops have drawbacks: they are more expensive, require an electrical outlet, and are not suitable for all flooring types, such as laminate or hardwood, which can be damaged by the steam.

Regular mopping can also sanitize floors effectively when done with the right cleaning products and techniques, though it may require more effort. The main advantage of a traditional mop is its versatility, as it can be used on any type of flooring. Ultimately, the best choice depends on your floor type, budget, and cleaning preferences.

Professionals use various tools and cleaning solutions based on the type of floor they’re cleaning. They often use industrial steam cleaners to pull debris out of the carpet. For localized stains, they may use a commercial cleaner or a mixture of water, vinegar, and dish soap. For tile, they’ll typically use dish soap and hot water, plus a mixture of baking soda and hot water for the grout. For cleaning wood floors, they might use a low-heat steamer, a mop with an oil wood floor cleaner, or a mixture of hot water, vinegar, and lemon juice.

Using too much soap or floor cleaner can leave your laminate floors looking dirty or cloudy after mopping. Only use a teaspoon of soap or cleaning solution in a gallon of water. Additionally, always be sure to sweep or vacuum laminate floors before mopping to ensure you pick up dried grit, hair, and dust that can be harder to catch with a wet mop.

Before starting on a full refinishing project, determine if your floors need to be completely sanded down to the bare wood or if the damage is shallow and mostly cosmetic. Deep scratches and gouges will require you to rough sand using a drum sander or belt sander, but small surface scratches or floors that have only lost their luster don’t need a complete overhaul. Instead, you can skip the rough sanding step and sand-screen the old finish with a buffer, removing only the top layer of polyurethane.