Get matched with top deck cleaning pros in Goodland, KS

Before installing a deck, you must build a base for the deck to rest upon, often made of compacted soil or gravel. While gravel is an optional material, it helps with drainage. Some contractors also recommend installing a weed control membrane, which helps provide a solid foundation for the frame. In the case of an elevated deck, a pro will often lay down a concrete slab as a foundation. 

The overhang, or nosing, of deck steps is another area that will be covered in building code requirements. The noses on your deck steps should have a minimum overhang of ¾ inch. For safety, usability, and code compliance, the nosing of deck steps should not extend past 1¼ inches.

If you want to make a deck cleaner from products already in your home, there are various options. The most common is to use a gentle blend of 1 gallon of warm water and 2 tablespoons of ammonia-free dish soap. You can also mix water with distilled vinegar. Sprinkling on some baking soda can help to remove mold and mildew. You can add oxygen bleach (but never damaging chlorine bleach) to the water and ammonia-free dish soap solution for something a bit stronger. 

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.