Get matched with top floor polishers in Enterprise, KS

After carpet removal, prepare for new flooring by assessing the subfloor. You will want to address any imperfections to create a smooth and level base for installation. Remember, proper subfloor preparation is crucial for optimal new flooring results. Consider repairing and replacing damaged areas for a stable foundation. For both wood and concrete subfloors, consider sanding to remove any debris or adhesives remaining thoroughly. 

Yes, you can mop hardwood floors with a damp flat or string mop as long as it is not soaking wet. Always avoid leaving standing water or fully soaking your hardwood floors, even if they are properly finished. A slightly wet mop, with or without cleaning solutions, will not damage the wood.

Most DIY floor cleaners don’t require rinsing, but you’ll want to make sure you don’t add too much dish soap or oil to the cleaner to avoid having to rinse it after cleaning. For non-wood floors, mix 8 parts warm water, 1 part vinegar, and 1 part baking soda with a few drops of dish soap. For wood floors, use olive oil in that same mixture instead of the vinegar. You can let these solutions air-dry after cleaning your floors with them, although you should manually dry your floors if they aren’t waterproof.

Before starting on a full refinishing project, determine if your floors need to be completely sanded down to the bare wood or if the damage is shallow and mostly cosmetic. Deep scratches and gouges will require you to rough sand using a drum sander or belt sander, but small surface scratches or floors that have only lost their luster don’t need a complete overhaul. Instead, you can skip the rough sanding step and sand-screen the old finish with a buffer, removing only the top layer of polyurethane.