Get matched with top buffing and polishing pros in Ellis, KS

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

If you would rather use vinegar to clean the stone fireplace instead of dish soap, this mixture should work fine. Vinegar is slightly acidic, however, so it may etch some kinds of stone without quite a bit of diluting. For a stone fireplace, dilute it to about one cup of vinegar for every gallon of hot water. It’s a smart idea to test the diluted mixture in an inconspicuous area of the fireplace and watch for etching. You can use vinegar to clean quite a few different items around your home, and it’s especially good at removing stains.

It is possible to buff and polish your floors yourself, but DIY floor polishing is an extremely time-consuming process that isn’t particularly enjoyable. To do the work yourself, you’ll usually need to clean your floors, get on your hands and knees to apply polish manually with a cloth, and avoid puddles and oversaturation. Hiring a professional floor polisher is usually worthwhile because they have industrial equipment that buffs and polishes in a fraction of the time and usually leaves a more even coat.

Routine sealing, avoiding heavy loads, and proper drainage improve lifespan. Regular inspections help catch and remedy problems early.