Get matched with top roofers in Deerfield, KS

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

There’s no single best roofing material for flat roofs, but EPDM is considered an excellent option because it lasts longer than TPO roofing and built-up roofing, and it’s the most adaptive to extreme temperatures and variations in temperature. EPDM can also be highly energy-efficient at both ends of the climate spectrum, with black EPDM helping to reduce heating bills and white EPDM helping to keep your building cool in extreme summer temperatures.

The easiest way to tell if your roof vent boot is leaking is to look in your attic for signs of water damage. You might see visible moisture, water spots, or mold on the roof decking around the roof vent or damaged or soggy insulation below it. If you don’t have access to your attic or aren’t sure if the vent boot is the issue, hire a professional to come inspect your roof and figure out the underlying issue.

Fall is widely considered the best time of year to replace a roof. The moderate temperatures are ideal for roofing crews to work and for new shingles to seal properly. Additionally, autumn weather is often drier, reducing the risk of weather-related delays compared to the rainier spring season.

While spring is also a viable option, the higher chance of rainfall can slow down the project. The main drawback to a fall installation is that it's the peak season for roofers, which can lead to higher prices and scheduling challenges.

To potentially save money, you could consider scheduling your roof replacement during the summer or winter off-seasons. However, both seasons have significant disadvantages. Extreme summer heat can make shingles too soft to handle, while winter's cold, snow, and ice can create dangerous working conditions and prevent shingles from sealing correctly, as they typically require temperatures above 40-45°F.