Get matched with top well and pump technicians in Wanatah, IN

Another common question is, what pressure should your well tank be set at? The standard rule of thumb is to set your well tank’s pressure at 2 psi below the cut-on point of your pressure switch. So if your well is set up for a high cycle of 40/60 psi, your pressure should be set to 38 psi. If you use a low setting of 30/50 psi, you would set the pressure to 28 psi.

Both can deliver clean water to your taps, but well water and city water carry a few differences. City water is delivered and connected through a main water line, and it travels through a network of underground private and public pipes to service various buildings and structures once it’s been treated.

Well water is derived from dug or drilled wells that source groundwater from the water table. City water is often more expensive than well water, but it eliminates the need for you to test and treat your own well water.

Most professionals recommend that a deep well pump shouldn’t run more than 10 hours consecutively before cycling off. Overworking the well pump beyond the recommended amount can prematurely wear out your pump and burn out the motor, which means replacing it more often than you otherwise should need to. Your well pump should also come with the manufacturer’s use and maintenance recommendations that are specific to the model.

There are many reasons you may want to extend the depth of an existing well or drill a new, deeper well on your property. A deeper well can tap cleaner water sources—shallow water may contain more contaminants. With a deeper well, you’ll also have an easier time reaching the water table depth (the level at which underground water is found) and can get past tricky soil conditions. 

Plus, if your local building code requires a minimum well depth for safety and environmental standards, you’ll meet the code by digging a deeper well in the first place.