Top-rated radon detection and reduction specialists.

Get matched with top radon detection and reduction specialists in Eaton, IN

Enter your zip and get matched with up to 5 pros

Need a pro for your radon detection and reduction project in Eaton, IN?

Select your specific project to find the pro for you.

Find Radon detection and reduction specialists in Eaton

Avatar for Air Xray
Air Xray
3.3(
111
)
Radon Gas - AbatementRadon Gas - Testing

Serving Eaton, IN and surrounding areas

Approved

In business since 2019

Free estimates

Warranties offered

"Get quote from air xray before getting your system installed. This company has unique way to install system without making hole in your wall. A little expensive but very professional and experienced in this area."
CO2
CO
Solutions
Radon
Sick Building Syndrome

+6

Response time2 days
88 neighbors recently requested a quote
Recommended by81%of homeowners
Radon Detection and Reduction questions, answered by experts

The soil beneath your house is most likely what’s causing an increased level of radon. This is because soil holds radioactivity for a long time and it’s also what most buildings are built on. Another common source of radon is water from a source that hasn’t been through periodic radon tests, such as well water. Over time, the radon from the soil can inhabit other parts of your house like the foundation or plumbing.

No level of radon is technically safe, but since it is naturally present everywhere, it is impossible to avoid entirely. The average radon level in homes across the United States is 1.3 picocuries per liter (pCi/L). The Environmental Protection Agency (EPA) recommends taking action to reduce radon levels if your home's test results are between 2 and 4 pCi/L or higher.

Many radon fans carry a five-year manufacturer's warranty. That said, your radon fan should last between five and ten years. Regular inspections will ensure the fan is operating properly. Unusual or exceptional noise coming from the fan or indications on your manometer or system monitor can immediately tell you that something is amiss.

A homeowner can install a radon mitigation system on their own. But it’s a challenging DIY that requires a lot of knowledge about radon mitigation as well as familiarity with local regulations. You do not want to risk an improper installation that leaves the system unable to detect radon or gives it a shortened life span. Relying on a professional is the surest way to guarantee a successful installation.

The average radon mitigation system uses about 876 kWh of electricity per year, although the exact amount of electricity used will vary depending on the size of the radon fan. Once the system is installed, the annual increase to your energy bill could range from $30 to $300 per year, again depending on the size of the fan.

The Eaton, IN homeowners’ guide to radon detection and reduction services

From average costs to expert advice, get all the answers you need to get your job done.