Get matched with top pool table assembly pros in Willow Springs, IL

It's not ideal, and if your pool’s pH is seriously low (below 7), swimming can be dangerous until you raise it, potentially causing severe irritation and damage to the skin and eyes.

Keep in mind that low pH can also be responsible for damaging the pool itself. Acidic water can contribute to the cracking of your pool's liner, which may cost up to $2,500 to replace, making this an expensive fix.

You can spend less time and money on plunge pool maintenance since they are smaller than standard pools. These pools are easier to clean and maintain yourself than a swimming pool. But like any pool, you’ll need to clean the pool walls and floor, balance the chemicals, check the electrical equipment, make necessary repairs, etc.

The total time to install an inground pool typically ranges from 8 weeks to 4 months. This timeline can be influenced by several factors, including permitting, site preparation, and the construction process itself.

Key phases and their typical durations include:

• Permits: Obtaining necessary permits can take anywhere from two to six weeks.

• Excavation and Site Preparation: This phase takes about a week but can be extended by problematic soil, unexpected ground conditions, or the need to move underground utility lines.

• Construction: The actual build, including plumbing and electrical work, often takes one to two months. The pool material is a major factor here; a concrete pool needs about 30 days to cure, while installing a fiberglass or vinyl liner is much faster.

External factors can also cause significant delays:

• Contractor Availability: Spring and summer are busy seasons, and high demand can lead to long waitlists, potentially adding months to your start date. It is often recommended to start planning and getting estimates up to a year in advance.

• Other Delays: Weather, material shortages, complex designs, and other unforeseen challenges can extend the project timeline.

It’s fair to be concerned about handling pool lights or wiring in a pool filled with water. But fortunately, pool lights and swimming pools are designed to make it easy and safe to replace the lights without needing to drain the water. Instead, you can turn off the electricity to the pool as a safety precaution, unscrew the pool fixture, pull it up and out to the side of the pool, then change the bulb.