Top-rated stucco pros.

Get matched with top stucco pros in Arthur, IL

Enter your zip and get matched with up to 5 pros

Need a pro for your stucco service project in Arthur, IL?

Select your specific project to find the pro for you.

Find Stucco pros in Arthur

A & A Construction
New to Angi
Synthetic Stucco - Install or Completely ReplaceSynthetic Stucco - Install or Completely Replace- For BusinessSynthetic Stucco - Repair or Partially Replace- For Business+4 more

Serving Arthur, IL and surrounding areas

In business since 2012

Free estimates

Warranties offered

Our professionalism and quality craftsmanship will earn your trust for a lifetime. We enjoy making all of clients repeat clients. We are known for our prompt service and superior attention to detail. You can be assured you're in good hands with A & A Construction. Call Larry today you'll be pleased you did. Thank you

Stucco questions, answered by experts

When cleaning stucco siding, it is recommended to use a pressure washer with a psi (pounds per square inch) between 1,500 and 2,000. This range provides sufficient power to remove dirt and grime without causing damage to the stucco surface. It's important to avoid using excessive psi as it can chip or crack the stucco. 

Using a wider spray nozzle and keeping a safe distance of about seven to 10 feet from the siding helps ensure a gentle and effective cleaning process. Always follow the manufacturer's guidelines and adjust the psi accordingly based on the condition of your stucco and the specific requirements of your pressure washer.

The best tape that works on stucco is the kind made explicitly for stucco surfaces. Look for tape that specifies stucco, masonry, or cement installations. The adhesive usually needs to be thicker and more durable to remain stuck to these rough surfaces.

Properly maintained stucco can enhance insulation, reducing energy loss.

To maintain stucco, inspect it annually for cracks and clean the surface with a mild detergent. Seal any cracks promptly to prevent water infiltration, and reseal or repaint as needed to preserve its appearance.

Yes, you can screw directly into stucco. Only do so if the item you are installing is a permanent fixture. Drill a pilot hole into the stucco using a masonry or concrete bit, then drive in the screw with a power drill or screwdriver.

The Arthur, IL homeowners’ guide to stucco services

From average costs to expert advice, get all the answers you need to get your job done.