Get matched with top gas log pros in Ucon, ID

If your home uses more than one gas appliance, you'll continue to use gas, even outside of the heating season. Your water heater, gas stove and oven, and gas dryer will all use some gas, although typically much less than a furnace. Additionally, those appliances may also have a pilot light that is lit continually, using a small amount even when no one is at home.

Installing a gas line is no simple task. From start to finish, you’re looking at anywhere from six to 12 weeks to acquire the correct permits, dig a trench, and connect your appliances. Naturally, the longer the gas line, the longer it will take to complete. If your plumber needs to hire additional contractors to dig trenches and navigate around or remove obstacles, this could put you at the longer end of the timeframe. 

Once the land is prepped and licenses acquired, installing the actual line may only take a few days to a few weeks, weather permitting.

Even if you invested in the cost of a gas shut-off valve for your oven and other appliances, it’s a good idea to add a seismic shut-off valve as an extra safety measure. 

Gas shut-off valves for appliances are manual, meaning someone has to cut off the flow of gas. This leaves room for error, as you might not be home or might be too distracted to think about gas lines during an earthquake. An earthquake valve is automatic and will protect your home from gas-related disasters in the event of an earthquake.

Call 811 to locate and mark the gas lines at least three days before digging. In many areas, you can dig within 18 inches of the lines, though in some locations, the distance may be further. Check local regulations, as you may need a utility company representative onsite when digging. Document your calls to 811 and precautions taken to avoid gas lines. A homeowner can be held liable for hitting a gas line in some cases, but contacting the proper authorities and following all guidelines can offer protection.