Top-rated contractors.

Get matched with top contractors in Franklin, ID

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Franklin, ID?

Select your specific project to find the pro for you.

Find Contractors in Franklin

Avatar for Jeffreys Painting
Jeffreys Painting
5.0(
11
)
Major Home Repairs (General Contractor)

Serving Franklin, ID and surrounding areas

In business since 2023

Free estimates

"Jeff was amazing. Jeff was able to not only exceed my expectations in quality and efficiency but made the work exciting. His upbeat personality made the process painless. I would definitely use Jeff again in a heartbeat."
After
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+1

Recommended by100%of homeowners
Avatar for Homemade Design
Homemade Design
3.7(
322
)
Major Home Repairs (General Contractor)

Serving Franklin, ID and surrounding areas

In business since 2006

Credit card accepted

"I never contacted the provider or used this service in anyway. I have to
write this review so that the request to write this review stops
popping up.
The rating is bogus as it is required to be able to submit.
"
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Frontier Mill & Construction, LLC
5.0(
2
)
Major Home Repairs (General Contractor)

Serving Franklin, ID and surrounding areas

In business since 2004

Free estimates

Emergency services offered

"Excellent service & response. Did not just install carpets; renovated entire home. Wall repair, painting, carpet installation, linoleum installation, caulking, powerwashing, co-ordinating countertop relacement, ceiling fan installation, deck reconstruction and more. An excellent company to work with. Actually, 6 star rating in my opinion. -Jack."
Recommended by100%of homeowners
Showing 1-10 of 21
Unfinished Carpentry questions, answered by experts

Yes, a 2x6 should hold a porch swing and safely support the load. A smaller joist runs the risk of it not offering enough support for the swing. If you have a joist smaller than 2x6, add additional bolstering support.

Converting a carport into a garage can vary in difficulty depending on its configuration, the condition of the foundation or slab, and its location relative to the house. The process has a lot in common with a home addition, but you can often skip non-essential finishes like fine flooring, trim work, or even drywall and HVAC. The conversion requires experience with drywall, insulation, and other building materials to ensure it’s done safely and correctly. While it might be possible for a DIYer with the proper tools and skills to do the work, it is a complicated and potentially dangerous job. If you’re new to basic construction, it's best to leave this project to the professionals.

Using a steel frame may raise the value of your home. Steel is more heat resistant, has better longevity, and doesn’t need any upkeep compared to traditional wood. You can also customize a steel build a little easier than other materials like brick, concrete, and vinyl—which have trouble bending and adapting to renovations.

A-frame homes are on the smaller side. While there’s no set square footage amount it has to be, it will usually come in around 1,000 square feet or smaller.

Metal stud framing parts include the studs themselves, upper and lower tracks that act as top and bottom wall plates, various angle fasteners and clips, screws for fastening pieces togeher, metal straps, c-channel supports, and thicker steel supporting structures. Roof framing metal components include pre-fabricated trusses, heavy-gauge stud pieces, and various plates and fasteners.

The Franklin, ID homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.