Get matched with top floor polishers in Ashton, ID

To properly maintain and care for hardwood floors without damaging the finish, establish a regular cleaning routine. Sweep with a broom or microfiber dust mop daily, or vacuum weekly, to remove dirt and debris that can scratch the surface; be sure to clean in tight corners and under furniture. For a deeper clean, use a damp mop with a cleaner specifically designed for hardwood floors, but avoid using harsh chemicals or excessive water, as this can damage the wood. You can further protect your floors by placing mats at entryways to catch dirt and moisture and putting felt pads under furniture legs to prevent scratches. For long-term care, refinish the floors as needed to keep them looking their best.

If you have waxed floors or floors with a penetrating stain or oil, you can shine them up with some more wax and a cloth or floor buffer. After cleaning the floor thoroughly, apply wax to the floor in small sections and use a clean, dry cloth or towel to buff it until it shines. You can also use an electric polisher, which is especially handy for large floors.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

If your floor is still sticky after mopping, chances are you used too much or too little of the cleaning solution. Using too little won’t get all of the grime off, but using too much can leave its own residue. Refer to the cleaning solution’s instructions and dilute it as directed.