Get matched with top drywall pros in Odebolt, IA

Wall anchors are suitable for drywall and plaster walls, which are common in most homes. However, different wall materials may require specialized anchors. For concrete or masonry walls, you'd typically use concrete anchors. When dealing with other wall types, such as brick or tile, specific anchors designed for those materials may be necessary. Always consult with a hardware specialist or check the manufacturer's recommendations to ensure you select the appropriate anchors for your specific wall type.

Generally, shower walls should not be installed over drywall because of the moisture issues this can cause. If you’re using a direct-to-stud shower kit, you need to remove the drywall before you can do the installation.

However, if you’re using a glue-up shower kit or stall, you can glue the shower walls directly to drywall. Be sure to install a moisture-resistant drywall or waterproof cement board.

No, rough-in plumbing is one of the last steps before your drywall goes up. This is because essential things like pipe installation require space before other elements go up. After the rough-in plumbing is complete, your inspector will also come to conduct an examination and tell you if your plumbing is approved and satisfies your building permit.

To hide drywall edges, you need to properly apply drywall tape and multiple layers of joint compound. These materials hide the seams between drywall sheets and fill the holes from drywall screws, leaving behind a smooth, flat finish to paint over. Apply joint compound smoothly, and finish the job by sanding the walls to make sure you fully hide drywall edges and other imperfections.