Get matched with top pool and spa technicians in Doon, IA

Most hot tubs use between 1,500 watts and 6,000 watts of electricity, depending on the voltage of your heater. 120-volt heaters tip toward the low end, and 240-volt heaters tip toward the high end. Expect your pump to add another 1,500 watts. Newer, energy-efficient models use less electricity, while older models use more.

The best thing with which to clean a hot tub is whatever the manufacturer recommends; in most cases, this is a gentle surface cleaner and a soft cloth. Recommended hot tub cleaners can include specially formulated cleaning agents, mild dish soap, baking soda, vinegar, or diluted bleach. For your hot tub exterior, choose wood or vinyl cleaner (depending on the casing material).

You should never use household cleaning products, harsh chemicals such as undiluted bleach or acids, or abrasive cleansers or cloths, as these can scratch or etch your hot tub’s coating or shell and cause permanent damage.

For a fully-foamed hot tub, freezing typically occurs when the temperature drops below 28 degrees Fahrenheit and remains at or below this level continuously for a minimum of 36 hours. If your hot tub and pumps are still operational, however, the water circulates, and this continuous movement helps prevent freezing, even in very cold conditions. This circulation, along with the insulation provided by the foam, helps maintain the water temperature and prevent it from freezing during extended cold periods. Still, if you’re not planning to run it regularly, be sure to winterize the hot tub properly to prevent damage from freezing.

Hot tub repairs cost between $200 and $500 on average. You can minimize those costs by maintaining your hot tub and keeping necessary supplies on hand. An elevated shelf in the garage is a great place to store your water care chemicals so that kids and pets will stay safe and you’ll always have them around. 

Your hot tub should be drained of existing water, cleaned, and refilled every three to four months at a minimum. Follow your tub manufacturer’s recommendations for cleaning, and rinse thoroughly when finished to eliminate any residue from the cleaning products. This is also a good time to inspect your tub’s cover in good lighting for any leaks, tears, or other damage that might cause problems. 

Using your hot tub manufacturer’s suggested cleaners and methods, keep your hot tub filters clean to avoid a loss of water heat. This will help extend the filter’s useful life and efficiency. If the filter is more than two to three years old, replace it with a new one and buy a second filter to keep around as a spare.