Get matched with top epoxy flooring pros in Decorah, IA

Resurfacing a garage floor takes about eight hours on average, with another couple hours over three days to do the epoxy. Epoxy goes on in three coats, with each coat taking 24 hours to dry and cure. You’ll need to keep foot and vehicle traffic off of your garage floor for around 4 days in total when replacing your garage floor, so be sure to plan ahead before you start. This is a great time to organize your garage since you’ll need to move everything out to apply the epoxy.

With so many vastly different options to choose from, how can you find an inexpensive garage floor that you can also confidently say is the best? The right solution will be different for everyone and truly depends on your individual needs and stylistic tastes.

If you’re working with a smaller budget, a low-cost coating such as paint, sealer, or stain might be the best way to express your style in the garage. If you need a high-performance surface that can handle the tough projects and maintenance you do in the garage, or if you want a wide range of colorful customization options, flexible tiles might be for you.

Concrete sealers will help your garage floors resist water, but they will not make the floor waterproof. You will need to purchase a specific waterproof floor paint for concrete and apply several coats over several days if you want your garage floor to be truly impermeable. While the process is similar to sealing the floors, the materials are different, and the need for multiple coats will extend the process and drying time.

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.