Get matched with top roofers in Akron, IA

You may become so frustrated with the look of moss on your roof that you contemplate whether to clean or replace your roof. Fortunately, you don’t have to go as far as replacing it. After cleaning the moss, you can use a chemical solution to keep it away. For further protection, trim branches that overhang the roof, as fallen seed pods and leaves on the roof allow moisture to collect, encouraging moss growth. Consider adding zinc-coated flashing to the roof, too. As rain washes across the zinc, it leaves zinc particles behind that inhibit moss growth.

A chimney cap costs about $300 on average to install, with prices ranging from $75 to $1,000. The final cost depends on several factors, including the professional you hire, the accessibility of your chimney, the cap's material and size, whether any repairs are needed, and if it requires custom fabrication. Chimney caps are usually made from galvanized steel, stainless steel, or copper. Copper caps are the most expensive, followed by stainless steel and then galvanized steel. Excluding labor, average material costs are around $100 for galvanized steel, $250 for stainless steel, and $600 for copper. You may also face additional costs, such as hiring a chimney sweep to clean the chimney before the cap is installed.

Asking questions before hiring a roofer ensures you receive the best quality for your investment upfront and in the long term. Roofers with minimal experience, unfamiliar with local building codes, or minimal access to great materials can lead to both structural and financial problems down the line. You should also be able to easily communicate and collaborate with your roofer during extensive projects.

Underlayment is required by building code, so any roof installed without it is technically against code. The underlayment acts as the second layer of defense against water, so installing a roof without underlayment means a much higher risk of roof leaks. You’ll have the best chance of avoiding roof leaks if you install drip edge flashing covered by underlayment, and then install your roofing material over that.