Get matched with top stucco pros in Winder, GA

The decision to repair or replace stucco depends on the extent of the damage. For minor issues like small cracks, holes, dirt, stains, or discoloration, a repair is typically sufficient and more cost-effective. These issues can often be resolved with a simple repair, a deep clean, and possibly a new coat of paint. However, for more significant problems such as large cracks, peeling, mold, algae, or structural water damage, a replacement might be necessary. In these cases, it is best to call a professional stucco contractor for an inspection. An expert can assess the severity of the damage, determine if there are deeper issues, and advise whether a repair is adequate or if replacing a section or an entire wall is the more cost-effective, long-term solution.

The cost of a repair depends on several factors, including the severity, complexity, and type of damage. Other key elements are the cost of any necessary replacement parts, hardware, materials, or required software updates. Labor rates and whether emergency service is needed will also influence the final price.

The best exterior paint finish for stucco is a flat or low-gloss finish. A high-gloss finish will show imperfections in the stucco and give it a candy-coated look that many homeowners don’t like. The best types of exterior paint to use on stucco are acrylic, masonry, and elastomeric. However, acrylic is recommended because it is both durable and breathable.

Stucco is very challenging to DIY, so it’s always best to leave the work to professional stucco contractors. The same recommendation applies to painting a stucco house, which should be left in the reliable hands of a professional exterior painter. Inexperienced DIYers can make several critical mistakes during stucco application, such as:

• Failing to apply sufficiently thick layers for longevity and water resistance

• Uneven application

• Uneven texture across the exterior

• Mixing the stucco improperly, leaving a weak structure

• Failing to texture properly in between coats, leading to cracking and chipping