Top-rated well and pump technicians.

Get matched with top well and pump technicians in Appleton, CO

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Appleton, CO?

Select your specific project to find the pro for you.

TRUSTED BY APPLETON, CO HOMEOWNERS

  • Average homeowner rating star icon4.9
    Average homeowner rating
  • Verified reviews icon20
    Verified well and pump services reviews

Verified Reviews for Well And Pump Service pros in Appleton, CO

*The Angi rating for Well And Pump Service companies in Appleton, CO is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Well And Pump Service needs.

*The HomeAdvisor rating for Well And Pump Service companies in Appleton, CO is a rating based on verified reviews from our community of homeowners who have used these pros to meet their Well And Pump Service needs.

Last update on June 10, 2026

Find Well and pump technicians in Appleton

Avatar for Choice Home Warranty
Choice Home Warranty
4.0(
5,678
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Appleton, CO and surrounding areas

In business since 2008

Emergency services offered

Credit card accepted

"Went well to this point of replacing parts. Then the United needed to have a system leak test and then needed freon put in pump. This was refused by Choice warranty. We were left with a partial repair and a heat pump not able to do it's job."
Recommended by81%of homeowners
Request Quote
Avatar for J & K Mechanical
J & K Mechanical
5.0(
1
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Appleton, CO and surrounding areas

In business since 2018

Free estimates

Emergency services offered

J & K Mechanical LLC is committed to excellence every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers' interests and make their concerns the basis of our business.

Recommended by100%of homeowners
Request Quote
Wells and Pumps questions, answered by experts

Normally, when your well pump turns on or off, you’ll hear a small click. This isn’t anything to worry about, but it can be a problem if it’s clicking continuously. This can indicate that the well pump is short cycling—the pump continuously turns on and off.

This can wear out the motor and provide uneven water flow. If this happens, you may need to get it looked at by a well pump professional to see if you need to repair the switch or pump.

How do you set your well’s pressure tank? All you need to do is first drain the tank of water and find the pressure switch. Remove the switch cover and adjust the switch with a wrench—clockwise to increase water pressure, and counter-clockwise to reduce it. Each complete turn of the nut on the switch should equal 2.5 psi. Once this is done, replace the switch cover. All that’s left is to adjust the pressure of the tank itself using an air compressor and a tire gauge to support the new setting.

DIY is not recommended due to safety and technical requirements. Hire professionals for accurate diagnosis and repair.

Common problems include low water pressure, no water, and strange noises. Regular maintenance prevents many issues.

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

The Appleton, CO homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.

See all articles