Get matched with top toilet pros in Barstow, CA

The order of your bathroom renovation should prevent damage to the completed work. Start with demolition and removing the old fixtures. Then, address structural repairs or water damage, if needed. Next, tackle the rough-in phase for plumbing and electrical work, install waterproofing, and work on wall treatments like tile or paint. Install your shower or bathtub, toilet, vanity, and sink. Flooring goes in after major fixtures but before the toilet. Lastly, install new lighting fixtures, mirrors, and other finishing touches as desired.

The amount of water wasted when a toilet ghost flushes depends on the cause of the ghost flushing. Leaky flapper valves tend to waste less water than a larger problem like a damaged flush valve that makes the toilet run constantly. Even if you don’t think you’re wasting a lot of water, it’s still a problem that should be fixed quickly. 

Yes, an ambitious homeowner could decide to replace their own toilet. A person attempting to do a DIY toilet installation should keep in mind that the average toilet weighs between 100 and 120 pounds. That means that you'll need to be comfortable lifting and carrying your old toilet and replacement toilet during both phases of the project. Additionally, homeowners will need to have basic plumbing knowledge to avoid plumbing problems that could result in messy, expensive water damage in their bathrooms. Hiring a plumbing pro from the get-go can help you avoid damaging your plumbing or your new toilet.

Toilets typically connect to your main vent stack, a vertical pipe that runs through all finished levels of your home and exits through the roof. It’s located behind the walls, but if you have an unfinished basement or a utility closet, you may find a portion of it running the vertical length of the space. Some basement toilets use an air admittance valve instead, which is a small vent located in the wall directly behind the toilet that extends upward a few feet from the drain.