Top-rated well and pump technicians.

Get matched with top well and pump technicians in Applegate, CA

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Applegate, CA?

Select your specific project to find the pro for you.

TRUSTED BY APPLEGATE, CA HOMEOWNERS

  • Average homeowner rating star icon4.8
    Average homeowner rating
  • Verified reviews icon24
    Verified well and pump services reviews

Find Well and pump technicians in Applegate

Larry Huggins Water Well Services
4.0(
2
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Applegate, CA and surrounding areas

In business since 2014

Free estimates

"Larry Huggins Water Well Services arrived on time for our appointment. The upgrade to the wiring for our irrigation pump was performed quickly and efficiently. We were given friendly advice and information about our system. We would hire this company again if we need the service."
Response time10 mins
Recommended by100%of homeowners
Avatar for American Home Shield – Home Warranty
American Home Shield – Home Warranty
3.5(
5,688
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Applegate, CA and surrounding areas

In business since 1971

Credit card accepted

"Well, the first time the replacement was ordered it was the wrong one, which of course, delayed the installation a week. When it was finally installed I had to pay an additional $850 for code upgrades. This I was not informed of by Home Shield. Then we noticed that there was water on the garage floor and found that the pipe coming in from the wall was leaking at the wall so had to call the plumbing company back out to fix it. They first tried to say it was not their fault but since there wasn't a leak before they installed they did fix it. I have used Home Shield a few times before and never had a problem. Some of the companies they use are not the best so you have to research them before you commit. I have found HS service to be good if you do your homework. At the end of the day I was without hot water for almost 3 weeks but it was do to the plumbing company they sent out."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+2

Recommended by65%of homeowners
All Kind Of Electrical And Plumbing Work
New to Angi
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Applegate, CA and surrounding areas

In business since 2005

Free estimates

Emergency services offered

All Kind Of Electrical And Plumbing Work is committed to excellence in every aspect of our business. We uphold a standard of integrity bound by fairness, honesty, and personal responsibility. Our distinction is the quality of service we bring to our customers. Accurate knowledge of our trade combined with ability is what makes us true professionals. Above all, we are watchful of our customers' interests, and make their concerns the basis of our business.

Wells and Pumps questions, answered by experts

Most well pump pressure switches have a factory setting of 30 to 50 PSI. There’s some flexibility with this if you’d like a lower or higher water pressure, but remember that it should sit 2 to 3 PSI above your well tank’s general pressure setting.

The inside of your pressure switch cover will usually indicate minimum and maximum settings—going below and above the numbers might damage your well pump.

If you notice any changes to the water coming from your well, consider that a sign to get a well inspection. For example, if the water is foul-smelling, bad-tasting, cloudy, or discolored, you should call a pro. It’s also a good idea to schedule an inspection if you observe a loss of water pressure, broken equipment, loss of well capacity, or other unusual signs.

Age is certainly a factor in well pump failure. The older your pump, the more likely it is to fail. 

Beyond age, other factors can cause your well pump to fail, too. Things like poor water quality can cause sediment buildup in your pump. Without proper cleaning, your pump can seize up and fail. Having a dry well for too long can also cause your pump to fail, as it keeps working even though there's no water for it to pull. 

If you have a self-cleaning washing machine but you’re still seeing lint, your water pump filter might be clogged. To clean it, you should unscrew the drain hose, then remove the water pump filter. From there, you can inspect it and clean it with warm water before replacing it. Check to be sure your washing machine is functioning by running a short cycle. 

Normally, when your well pump turns on or off, you’ll hear a small click. This isn’t anything to worry about, but it can be a problem if it’s clicking continuously. This can indicate that the well pump is short cycling—the pump continuously turns on and off.

This can wear out the motor and provide uneven water flow. If this happens, you may need to get it looked at by a well pump professional to see if you need to repair the switch or pump.

The Applegate, CA homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.