Top-rated well and pump technicians.

Best well and pump technicians near Hackberry, AZ

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Hackberry, AZ?

Select your specific project to find the pro for you.

Top-Rated Well and pump technicians in Hackberry - Updated Nov 2026

M & M Water & Well Services, Inc.
0.0(
2
)
Well Pump - Repair or Service

Serving Hackberry, AZ and surrounding areas

In business since 2003

Free estimates

With many years of experience serving the Mohave area, M & M Water & Well Services, Inc is the way to go for all your sump pump and well pump needs. We take great pride in our extreme professionalism, timeliness, and superior customer service on every job. We make sure to develop lasting relationships with our customers so that the next time service is needed, there will be no question on who to call. Contact us today for a free estimate. Satisfaction Guaranteed!

Recommended by100%of homeowners
Wells and Pumps FAQs, answered by experts

If the well pump is more than 10 years old, it's worth contacting a well pump repair pro near you and weighing the cost of repairs against buying a new well pump. Pumps can last a long time with regular maintenance, but if your pump is nearing the 10-year mark and starts needing repairs frequently, it’s time to replace it.

Repairs typically take 2-4 hours. Complex issues may require additional time.

The average three to four-bedroom home typically uses a well pump rated for 8 to 12 gallons per minute (GPM). To find the most accurate size for your specific needs, a common rule of thumb is to count the number of water fixtures and appliances in your home and aim for that number in GPM. This calculation allows for about one gallon of water per minute per fixture. Because estimating the correct size can be challenging, it's best to have a professional technician make the final determination. A professional can ensure your pump provides sufficient water for your home, especially during peak usage hours.

The pressure in a well pressure tank should be set 2 to 3 PSI below the pump's cut-on pressure. The cut-on pressure is the lower number in the pressure setting (e.g., the '30' in 30/50 PSI) and is the point at which the pump starts. The cut-out pressure is the higher number, where the pump stops.

For example:

  • If your pressure switch is set to 30/50 PSI, the tank pressure should be 27-28 PSI.

  • If your pressure switch is set to 40/60 PSI, the tank pressure should be 38 PSI.

Common pressure settings for household applications include 20/40, 30/50, and 40/60 PSI. The difference between the cut-on and cut-out pressure is typically 20 PSI.

How do you set your well’s pressure tank? All you need to do is first drain the tank of water and find the pressure switch. Remove the switch cover and adjust the switch with a wrench—clockwise to increase water pressure, and counter-clockwise to reduce it. Each complete turn of the nut on the switch should equal 2.5 psi. Once this is done, replace the switch cover. All that’s left is to adjust the pressure of the tank itself using an air compressor and a tire gauge to support the new setting.

The Hackberry, AZ homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.