Get matched with top sink repair pros in Hackberry, AZ

Today’s standard sink stopper size is 1.5 inches. However, you can still find different sizes if your house uses an older sink stopper. Other sizes you can find in most hardware stores include one inch, 1-1/4 inch, 1-3/8 inch, 1-5/8 inch, 1-7/8 inch, 2 inch, 2-1/4 inch, 2-3/8 inch, and 2.5 inch.

Yes, you can fit a vanity unit to an existing sink, especially if you plan to custom-build the vanity. With a prefabricated vanity, you’ll likely need to make a few adjustments. It depends on the type of sink, the size of the sink, and the existing plumbing. If you plan to retrofit a sink into a prefabricated vanity, make sure you take precise measurements and that your sink is compatible with the vanity you select. Prefabricated units have a precut sink hole, so you’ll need the size to match your sink.

Yes, a toilet, sink, and shower can share the same vent. This is a common plumbing practice that can simplify installation and save space. When sharing a vent, it's important that the toilet is located downstream from all other fixtures. You will also need to ensure the vent pipe is large enough to handle the demands of all connected fixtures without compromising its effectiveness. Because requirements can vary, you should always check your local building and plumbing codes. Consulting a qualified plumber is recommended to ensure the vent is properly sized, installed, and adheres to all local regulations.

Deteriorated seals, O-rings, or gaskets are common culprits behind a leaky sink after you’ve turned off the water—especially if your sink is older than 15 years. Inspect each of these mechanisms in your sink for signs of corrosion or looseness, then replace the worn-out part to fix it. Older sinks may be worth replacing if several of the parts are worn-out.