Top-rated deck cleaning pros.

Get matched with top deck cleaning pros in Ola, AR

Enter your zip and get matched with up to 5 pros

Need a pro for your deck cleaning project in Ola, AR?

Select your specific project to find the pro for you.

Find Deck cleaning pros in Ola

Avatar for Duraplex LLC
Duraplex LLC
4.5(
45
)
Deck, Fence, Patio or Porch - Clean and SealDeck, Fence, Patio or Porch - Clean and Seal - For Business

Serving Ola, AR and surrounding areas

In business since 2006

Free estimates

Emergency services offered

"Very professional, friendly, and prompt service.  They took time to explain what had caused the damages to the roof and what needed to be done to prevent the damages from re-occurring.  Also, they explained the benefits of a full roof replacement vs just repairing the damaged area. 
"
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+16

Recommended by91%of homeowners
...
Showing 1-10 of 51
Deck Cleaning questions, answered by experts

Deck stairs should have at least three stringers rather than two. The recommended minimum width for stairs is 36 inches, and the International Association of Certified Home Inspectors recommends at least three cut stringers to provide sufficient support on wood decking stairs of this width. Generally, stringers should be a maximum of 16 inches apart for wood decking and 12 inches apart for more flexible composite decking.

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

In the majority of cases, you don’t need regulatory permission or permits to remove decking components and materials. However, the exception is if you live in or near a wildlife conservation area, which could require permits and consent prior to beginning the demolition. Check with a local regulatory agency for more information.

Typically, most residential wooden decks are designed to support approximately 40 pounds per square foot, including the deck’s weight and any items placed on it. While this is fine for typical use, it is usually not enough to hold the weight of a hot tub filled with water and people. To safely support a hot tub, your wood deck will likely require reinforcement. Therefore, it’s best to have a contractor or a structural engineer assess it before hot tub installation.

In many areas, a floating deck that isn’t connected to your home and stays under 200 square feet and below 30 inches in height may not need a permit. These freestanding structures are often considered low-risk, which can simplify the building process. However, building codes vary greatly based on location. Before investing in any home improvement project, check with your local permitting office for deck-building guidelines.

The Ola, AR homeowners’ guide to deck cleaning services

From average costs to expert advice, get all the answers you need to get your job done.