Get matched with top cabinet makers in Horatio, AR

The 1/3 rule is a design guideline used by interior designers and cabinet installers to select appropriately sized pulls for cabinets and drawers. The rule suggests that for a balanced and cohesive look, a cabinet pull should be approximately one-third the height of the cabinet door or one-third the width of the drawer face. This guideline helps create a symmetrical appearance because the human eye tends to follow the length of the pull across the cabinet face.

While the 1/3 rule is a helpful starting point, it is not the only option. If a measurement falls between available pull sizes, it's generally best to size up. For an ultra-contemporary aesthetic, you can also opt for full-width pulls that span the entire drawer.

Walls in good condition with an even surface should be fine for frameless cabinet installation. Older, uneven, or warped walls could create problems. Your studs and their spacing are especially important, since frameless cabinets rely so much on wall attachments. Call in a professional installer for a consultation if you aren’t sure.

To install cabinet doors evenly, it’s important to make sure that all drilled holes and hardware are in their right places and aligned properly. You can achieve the ideal placement by using a level, straightedge, or other measuring tool. In the event that your cabinet doors are not installed evenly, most hinges allow you to adjust them so that your doors can be perfectly lined up. 

While a three-inch center-to-center handle is common, there’s no guarantee that sizing will be the same for every cabinet. Different types of handles have different sized holes to attach them and there are lots of different cabinet handle widths and styles. You should measure to be sure you know the size of a handle and to avoid surprises.